
18 DR
®
DUAL-ACTION ELECTRIC LOG SPLITTER
Chapter 4: Maintaining The DR DUAL-ACTION ELECTRIC LOG SPLITTER
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual for
maintenance procedures.
Regular Maintenance Checklist
PROCEDURE BEFORE
EACH USE
E
VERY 150
HOURS
Clean around the s
littin
Wed
e, Ram and Tra
s.
Check the S
littin
Wed
e for shar
ness.
Check the
eneral condition of the Lo
S
litte
e.
. nuts, bolts, welds, etc
.
Check the Wed
e for smooth travel.
Check the condition of the electrical cord.
Check the h
draulic fluid level
See “Addin
H
draulic Fluid”
in Cha
ter 2
.
Check Tire
ressure
Change the hydraulic fluid (See “Changing the Hydraulic Fluid”). 1
st
Time 25
Hours
General Maintenance Check (before operating)
The hydraulic system (hoses, cylinder, and pump) should be carefully inspected before each use. Also, inspect the mechanical
parts at the same time. Make sure all clamps, nuts, bolts, fittings, etc. are properly installed and tightened.
Always replace frayed, kinked, or cracked hoses and/or other damaged hydraulic components with DR Power Equipments
authorized parts and components specified in the “Parts” section (Chapter 7) of this manual. Replacement parts from secondary
suppliers (not original DR Power Equipments replacement parts) can lead to product damage and/or personal injury, and will void
the warranty.
Should it become necessary to loosen or remove any hydraulic fitting or line, be sure to relieve all hydraulic pressure by shutting
off the Motor, and moving the valve control handle back and forth several times until no cylinder movement is visible.
Before performing any repairs or maintenance procedure, unplug the wood splitter power cord from the power source.
Do not check for leaks with your hand. Leaks can be located by passing a piece of cardboard or wood around the suspected leak
and looking for discoloration. High-pressure fluid escaping from a very small hole can be almost invisible. Escaping fluid under
pressure can have sufficient force to penetrate skin, causing serious injury or even death. If fluid is injected into your skin, it must
be treated immediately by a doctor familiar with this type of injury.
Do not remove the cap from the hydraulic tank or reservoir while the Log Splitter is running. Hot fluid, under pressure, could be
expelled resulting in serious injury.
Comentarios a estos manuales